OIL TANK CONFIGURATIONS

Also View 'Oil Tank Configurations' Link In Left Column

Please note: Due to unforeseen differences in each aircraft, the kits shown may not fit your aircraft even though it is the same make and model. Communication with Smoking Airplanes LLC should be made in writing or by telephone to ensure proper fit before ordering.

SA-101 configured for the rear baggage area in a F1 rocket

SA-101 configured for behind the right seat in a van's RV6A

SA-201 configured for between the feet in the front seat area of a Pitts S2A

Please note: The owner/installer of this configuration reported extreme difficulty making this 5.5
gallon tank fit his S2A and recommends a different configuration or the SA-101 series (3.5 gallon)
system to S2A owners

SA-201 configured for between the feet in the front seat area of a Pitts S2A

Please note: The owner/installer of this configuration reported extreme difficulty making this 5.5
gallon tank fit his S2A and recommends a different configuration or the SA-101 series (3.5 gallon)
system to S2A owners

SA-201 configured for between the feet in the front seat area of a Pitts S2A

Please note: The owner/installer of this configuration reported extreme difficulty making this 5.5
gallon tank fit his S2A and recommends a different configuration or the SA-101 series (3.5 gallon)
system to S2A owners

SA-201 configured for the front baggage area in a van's RV8

SA-201 configured to be seat belted into the right front seat of a CAP-10

SA-201 configured to be seat belted into the right front seat of a CAP-10

View of SA-101 installed on old ADF rack in a Nanchang CJ6A

Note: if external fill kit is not used a better choice would be SA-101 (low profile so you can get
to the fill cap easier)

SA-101 with external fill kit installed on the old ADF rack in a Nanchang CJ6A

View of external fill fitting installed on the fuselage of a Nanchang CJ6A

 

SA-101 configured for rear baggage area in van's RV3

SA-201 custom configured for under the fuel tank of a Pitts S2B

View of installed SA-201 custom configured for under the fuel tank of a Pitts S2B

View of installed SA-201 custom configured for under the fuel tank of a Pitts S2B

SA-201 installed on old ADF rack in YAK 52

3/4" plywood platform on old ADF rack in YAK or CJ for installation of a SA-101

SA-101 installed in rear of YAK 52

SA-201 installed in baggage area of YAK 52

SA-201 installed on old ADF rack in CJ6A

Installed on ADF rack in YAK 52

Installed on ADF rack in YAK 52

SA-101 configured for front baggage shelf of van's RV8

SA-101 configured for front baggage shelf of van's RV8

SA-201 installed on old ADF rack in CJ6A

SA-201 configured to fit front seat of this CUB.
Ratchet straps were used to secure it in place

SA-101 configured for an Acrosport

SA-101 configured for the rear baggage area in a van's RV8

BACK TO TOP OF PAGE